Printable View
I was installing a GG short reset kit into my factory LEM HK45c, and the hammer strut fell out. Try and I might I can’t get it back in there.
Any helpful hints? The gap under the hammer assembly doesn’t seem to be wide enough to take the rounded nose of the hammer strut.
Figured it out.
When the hammer strut spontaneously disassembled, the cocking piece rotated.
Been in the same cuss fight with it myself, LEM is anything but intuitive compared with other actions.
Doing armorer stuff, I think I eventually hit every problem, figured it out, and then forgot the solution two years later when I was messing with it again.....
&#(@&#&!
The hammer won’t release at the back of pull.
Now what did I do?
I recently swapped out to LEM on my HK45c and encountered similar issues. I’ll see if I can send a link to the videos I rewatched. I believe I assembled/disassembled it several times and range time to make sure it was legit. Good times.
Thank you - I’ll try that!Quote:
Originally Posted by CakeEater
The function problem was a science project gone wrong. HK uses the same trigger for the HK45c and the USPc, so I decided to try the GG USPc flat trigger. No go, confirmed by GG. Hopefully they will offer one for the HK45c at some point, because I really like how their flat triggers work with LEM.