Printable View
Why not?
Clipdraw does not make one for a K-frame, but I had a spare J-frame model, so I tried it. It seems to fit decently.
My only concern is the supplied screw that replaces the OEM plate screw. Do the K-frame and the J-frame use the same screw pitch there?
the blued screw I used seemed to thread in smoothly, but if it's a different pitch I need to rethink this.
Photo proof, J-frame clipdraw on my PSA surplus 3" K-frame
https://i.imgur.com/3tN7f4i.jpg
If the question is specifically about thread pitch so you don't strip anything...Quote:
Originally Posted by onehalfmvsquared
For current production guns? Yes. The round head plate screw is the same J/K/L/N. I believe they use 2 of these now and have stopped using the flat head screw.
For your pre-1982 (pinned barrel) gun? Maybe. Read Hondo's post carefully. Depending on that "J-frame" clipdraw screw it may be #3-48 or it may match the K's #5-44 depending on when it was made.
I read Hondo's post carefully, thank you.
this gun is a 10-7, which is certainly post war, and the J-frame uses the same screw since about 1980.
So I conclude that yes, they do use the same screw.
If your clipdraw and screw were made after some indeterminate period in the 80s, that would be my understanding as well. I would still put the OEM screw and the clipdraw screw side by side under a loupe or magnifying glass and compare to be sure. But I don't know when your clipdraw was made. If it's recent manufacture then it's probably a safe bet.Quote:
Originally Posted by onehalfmvsquared
An aftermarket part made on (randomly guessing) May 12, 1983 would probably still target the old thread pitch, since on that date there are only a few guns with the new #5-44s and decades of old guns with the old #3-48s. In the pre-internret era it could take years for it to filter out that the change even happened.
To me, it seems as though that is a fair bit of weight, torquing and pulling on that tiny screw.
I might look at this, as my current holster make the grip on my K frame 66-8 ride too high for my comfort.
I have a 242 that I used a Clipdraw on for a while; worked well.