View Full Version : Holosun EPS carry/BUIS help
eric0311
09-16-2022, 05:52 PM
Help needed-
I will be mounting a Holosun EPS carry to a Glock 19 GEN5, via a CH precision mounting plate… what height iron sites should I use… I’d like to maximize as much of the optic as possible, by not occluding the sight picture with the sights.
psalms144.1
09-16-2022, 07:01 PM
Help needed-
I will be mounting a Holosun EPS carry to a Glock 19 GEN5, via a CH precision mounting plate… what height iron sites should I use… I’d like to maximize as much of the optic as possible, by not occluding the sight picture with the sights.Eric - I'd suggest the SCS, instead of the EPS on a plate. Mine sits low enough in the slide that I can see the factory NS at the bottom 1/3 of the glass, but they do not "distract" by being too tall.
eric0311
09-16-2022, 07:49 PM
Eric - I'd suggest the SCS, instead of the EPS on a plate. Mine sits low enough in the slide that I can see the factory NS at the bottom 1/3 of the glass, but they do not "distract" by being too tall.
Thank you for the response… I have already purchased the EPSc though…
eric0311
09-17-2022, 09:21 AM
I should’ve prefaced, I’m looking for a lower 1/3 co-witness with the BUIS…
mizer67
09-19-2022, 08:35 PM
I should’ve prefaced, I’m looking for a lower 1/3 co-witness with the BUIS…
Best to measure. Unless someone has the EPS carry and plate you're referencing, you'd be well served breaking out the micrometer.
Since it's a new optic, you're probably not going to get the answer you seek.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.