View Full Version : Original .22 Browning Challenger front sight pin
oakdalecurtis
05-27-2020, 12:16 PM
I need a new front sight pin for my original .22 Browning Challenger (1970). I have called ALL the usual new and old part suppliers, seems to be unobtanium. The pin is .250 long and .058 dia, at least the hole is. Short of making a new one, any thoughts?
Jim Watson
05-27-2020, 12:42 PM
A No. 54 drill bit is .055". Might be close enough to Loctite a quarter inch of the shank. Or sand down a No 53.
There is .058" spring wire but I don't know where you would find a small piece.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.