PDA

View Full Version : QD Suppressor mounting options



jc000
03-04-2020, 03:02 PM
I had asked this in a previously thread but thought I'd ask in a new one to see if anyone had any insights.

Who has experience with both the Q Plan B and Keymo systems? I have a Vox S and Turbo K2 I'll be swapping between a few rifles (.300BO and 5.56) and am considering the following options:

Direct thread Vox to .300BO, purchase single YHM QD mount to swap Turbo K between two 5.56 rifles – cheapest option but restricts ability to run Vox on 5.56 rifle
Q Plan B mounts and muzzle devices across the board – lightest and shortest option, but more costly and reports of issues with muzzle device to mount interface
Keymo mounts and muzzle devices across the board – very well regarded, bombproof option but heaviest, lengthiest, aand most expensive option
Centrix mounts and muzzle devices across the board – might be best balance of flexibility and weight / length but not out yet and unsure if Centrix mount would work with YHM can

Anyone have any experiences that they could share?

Hansohn Brothers
03-05-2020, 01:40 PM
I prefer the Plan A or the new YHM Micro mounts if you need a secondary retention mechanism. They will allow your cans to stay short as possible.

jc000
03-05-2020, 02:37 PM
I prefer the Plan A or the new YHM Micro mounts if you need a secondary retention mechanism. They will allow your cans to stay short as possible.

So for the Plan A I'd need to purchase the mount (https://hansohnbrothers.com/shop/griffin-armament/accessories/mounts-and-pistons/griffin-armament-plan-a/) for both the YHM and EA cans, and then any of the compatible minimalist muzzle devices for each rifle?

What's needed for YHM? Would this require the Kurz kit (https://hansohnbrothers.com/shop/yhm/accessories/mounts-and-pistons/yhm-kurz-kitz/) for both the Turbo K2 and Vox suppressors?

Thank you! How's that Form 4 looking! :cool:

Hansohn Brothers
03-06-2020, 09:06 AM
So for the Plan A I'd need to purchase the mount (https://hansohnbrothers.com/shop/griffin-armament/accessories/mounts-and-pistons/griffin-armament-plan-a/) for both the YHM and EA cans, and then any of the compatible minimalist muzzle devices for each rifle?

What's needed for YHM? Would this require the Kurz kit (https://hansohnbrothers.com/shop/yhm/accessories/mounts-and-pistons/yhm-kurz-kitz/) for both the Turbo K2 and Vox suppressors?

Thank you! How's that Form 4 looking! :cool:

Exactly correct. Form 4 is still pending! :)