Crash913
11-26-2019, 08:59 PM
Hi guys,
I have a two-week old Mark IV 22/45 bull barrel (target) model and I am having intermittent issues with inserting magazines. The magazines go 1/2 - 3/4 of the way in and then stops due to an obstruction. After looking closer, the magazines are hitting the sharp protrusion from the mag release button on the inside. If I depress the mag release 1/16” or so the mags will slide in perfectly. Looking at the right side of the frame, the magazine release button isn’t flush but about 1/16” indented. Any advice?
Thanks!
I have a two-week old Mark IV 22/45 bull barrel (target) model and I am having intermittent issues with inserting magazines. The magazines go 1/2 - 3/4 of the way in and then stops due to an obstruction. After looking closer, the magazines are hitting the sharp protrusion from the mag release button on the inside. If I depress the mag release 1/16” or so the mags will slide in perfectly. Looking at the right side of the frame, the magazine release button isn’t flush but about 1/16” indented. Any advice?
Thanks!