View Full Version : Old S&W 38spec.revolver
richinnj
10-30-2019, 04:48 PM
I have an old 38spec. with interchangeable barrels. The thread in the gun need to be retapt, but I can't figure out the tap size. The barrels look like 13mms with 32 tpi or pitch. Does anyone know for sure?
revchuck38
10-30-2019, 06:15 PM
Are you sure it's not a Dan Wesson?
BillSWPA
10-30-2019, 07:14 PM
Is the cylinder release behind the cylinder or in front of it?
Sent from my iPhone using Tapatalk
Baldanders
10-30-2019, 08:14 PM
Pics or it's not real.
I'm betting this is a Dan Wesson as well.
richinnj
10-31-2019, 05:14 PM
You guys are correct, it is Dan Wesson 38. Has three barrels, 2" 4" 6" only have the 4" barrel will not screw into body. Threads on barrel ok , don't want to cross thread by screwing barrel in. Can't determine threads on barrel. Checked with thread gauge, 32 tpi. that's all I know, could they be metric?
Lost River
10-31-2019, 06:24 PM
richinnj
What model number is the DW revolver?
Also, you might try asking here:
https://www.danwessonforum.com/forum/
Half Moon
10-31-2019, 06:30 PM
From a thread over at danwessonforum.com
https://www.danwessonforum.com/forum/general-messages/barrel-the-frame-thread/
CALIBER Thread Diameter Pitch ID at forcing cone
357SM .657 32TPI .357
375SM .686 32TPI .371
41Mag .656 40TPI .417
414SM .656 40TPI .417
44Mag .686 40TPI .426
445SM .686 40TPI .426
45Colt .688 36TPI .450
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.