M&P 9C (Gen. 1) slide milling

[BigSky]

Has anybody here had the slide on their Gen 1 M&P 9C milled for a red dot? Maybe my GoogleFu skills are lacking at the moment. What I'm specifically looking for is to have my slide milled while keeping the rear sight where it is, at the back of the slide, with the Red Dot mounted in front of it. Has this/can this been/be done? I have seen pictures of it done where the red dot is so far back that there is either no rear sight or the rear sight is mounted in front of the red dot sight (toward ejection port). I'm going to post this on a couple of others also; but, any input would be appreciated. Thanks in advance.

[PD Sgt.]

I do not have pics available, but ATEi did exactly the work you described for me on a first gen 9c. Excellent work, I would certainly recommend them. They also did a G19.3 for me that was just as good.

[DocGKR]

Yes, we had a number of them done by Mark Housel at L&M: https://www.landmprecisiongunworks.com

[BigSky]

Thanks gentlemen, I appreciate it.