View Full Version : Crimson Trace problem
I have the CT laser grip for my M&P and I just started to have problems with it not holding zero. Does anyone else have this problem? Is there an end user fix i.e., thead locking compound or should I contact Crimson Trace and see if I can get them to take a look at it? Thanks.
ToddG
01-03-2012, 07:36 PM
Back both the elevation and windage screws out a few rotations -- not enough to have them unthread, you'll never get them back in -- and re-zero. See if that helps. If not (and assuming for the sake of argument that you're certain it's the laser and not you) then you need to contact CTC.
Back both the elevation and windage screws out a few rotations -- not enough to have them unthread, you'll never get them back in -- and re-zero. See if that helps. If not (and assuming for the sake of argument that you're certain it's the laser and not you) then you need to contact CTC.
Thanks! I will give that a try first thing tomorrow.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.