dragonmouse
04-29-2017, 05:15 PM
May be a silly question, but while not a showstopper it's really annoying. Have been loading a few years on a dillon 550b that I was given
and while the primer feed can be an issue, I don't really load fast enough that I can't deal with the occasional problem. My issue is while depriming
and sizing in the station the primer that gets removed seems to go the the four winds. Have tried catching them in a box on the floor,
with minimal success. I don't see any additional parts on the diagrams or people's setups that would address this. Sometimes they fall in or around the priming
bar and travel area of that bar, causing me to stop and physically remove it.
I can deprime a large number of rounds and then just sweep up, to begin loading or deprime on other equipment and eliminate the whole issue. I just want to make
sure I am not missing something. Thanks for the time.
and while the primer feed can be an issue, I don't really load fast enough that I can't deal with the occasional problem. My issue is while depriming
and sizing in the station the primer that gets removed seems to go the the four winds. Have tried catching them in a box on the floor,
with minimal success. I don't see any additional parts on the diagrams or people's setups that would address this. Sometimes they fall in or around the priming
bar and travel area of that bar, causing me to stop and physically remove it.
I can deprime a large number of rounds and then just sweep up, to begin loading or deprime on other equipment and eliminate the whole issue. I just want to make
sure I am not missing something. Thanks for the time.