KG
08-24-2016, 01:46 PM
I'm planning to install a new/old stock stainless Elite II Barrel in my lightly used slide. Should I take the locking block off the original barrel and install it on my new barrel so the wear matches the slide? Or should I just use the new locking block that I already installed on the new barrel?
The new locking block appears to fit the slide well. There is no light in front of the lugs when it is placed in the slide. Also, I coated the front of the lugs with magic marker. After I cycled the action and took the barrel out, I could see that the front of both lugs completely contacted the slide.
Thanks
http://i210.photobucket.com/albums/bb245/Keith_Groen/Mobile%20Uploads/image_3.jpeg (http://s210.photobucket.com/user/Keith_Groen/media/Mobile%20Uploads/image_3.jpeg.html)
The new locking block appears to fit the slide well. There is no light in front of the lugs when it is placed in the slide. Also, I coated the front of the lugs with magic marker. After I cycled the action and took the barrel out, I could see that the front of both lugs completely contacted the slide.
Thanks
http://i210.photobucket.com/albums/bb245/Keith_Groen/Mobile%20Uploads/image_3.jpeg (http://s210.photobucket.com/user/Keith_Groen/media/Mobile%20Uploads/image_3.jpeg.html)