Glock 9mm Magwell/+2/3 Mag Bases/Mag Springs & Followers

[Jinkster]

I want to upgrade all my mags with +2/3 mag bases, upgraded mag springs, and I used to have these very hard and slick upgraded followers...they were gray in colored and made of extremely hard plastic and moved through the mag bodies slick as grease..I'd like to find those again...all for the Glock 17rd 9mm mag bodies.

I'm also looking for a particular magwell...they are made of solid brass...they register and fill up the hollow cavity in the rear grip area.

any suggestions of where to look here? T.I.A. Bill.

[Chipster]

The Taylor Freelance Seattle Slug is the one I think you're thinking of. I'm not sure about the followers but here's the other link.

http://taylorfreelance.com/blog/?page_id=38

[Little Creek]

I have six Glock +2 magazines for my G17. I suggest you also get extra power magazine springs to go with the +2 floor plates and inserts. My OEM mags are 100% reliabile, never been taken apart, never cleaned, except to convert to the +2 capacity. I see no need to replace the followers on my magazines. I have 25 total for my G17.

[Chuck Haggard]

I run a lot of Glock +2 G17 mags with the 11 coil G22 magazine springs, these have been 100% solid as far as reliability and durability. I tested that combo extensively before I started carrying them, and after I did that dozens of guys on my job started doing the same, no issues noted.

[HopetonBrown]

TTI mag wells are solid brass. I like his +3 base pads. I gave not needed to change followers or springs.

[Gray222]

Taran tactical has worked for me....got these from joshs used...


http://i.imgur.com/Y1GqCcB.jpg