@Flamingo
Here are a couple of pics. The paperclip piece started straight and the spring pressure bent it. I had it attached to the rest of the paperclip but another piece got bent so I just used this little piece (that used to be straight)
A small adjustable wrench works well at pushing the mainspring seat down enough to disengage the bent paper clip. You may want to use a small finishing nail instead of that style of paperclip, it seems to be to flimsy.
I had a small cotter pin on the desk and it worked fine.
Last edited by SwampDweller; 04-23-2024 at 10:42 PM.
You can also use a vise, use padding material so that the vise jaws don't mar the strut; place the strut in upside-down, and simply use a fork to push down on the spring to allow placement of the seat.
Best, Jon
Sponsored by Check-Mate Industries and BH Spring Solutions
Certified Glock Armorer
Back in the old days, I think most GP-100s and SP101s came with a small length of drill rod or brass rod to put through that strut 's small hole. I know I lost a few of them back when I was playing musical chairs with revolvers.
Before we moved, the nearby tool and die place used to have a can where all the trashed or broken off twist drill bits went. I went over there with a GP100 strut one day and asked if I could go through the can and find the best close-but-not too-close fit for that takedown pin hole. "Take all you want! Just don't bring any back."
I cut off all but the shank that goes in the drill chuck, took the shank and rounded off the raw end, after which I polished it. The shank should be tough, but not hardened quite like the cutting portion. Makes a dandy, non-bending tool to capture that spring.
gn
"On the internet, nobody knows if you are a dog... or even a cat."
There's a 3" stainless fixed sight GP100 I have my eye on. It would make a decent carry gun with a good IWB holster.
Regarding the vetting subject again, for a serious use defensive carry .357 Magnum revolver that is going to be carried loaded with .357 Magnum ammo, how many rounds of Magnum and how many rounds of Special does it take to consider a particular GP100/revolver "vetted" as reliable?
In my opinion, 200 rounds of range/target ammunition, and 1 box of defensive cartridges would be my minimum..
It would also be ideal to use it in at least one IDPA match (or similar) or training class to help vet you with the revolver in conjunction with you mechanically vetting the gun.
Keep in mind that to me, the vetting process encompasses the gun, you, and your equipment associated with carrying the gun-holster, speedloaders, speed strips, pouches, belt, etc.
Best, Jon
Sponsored by Check-Mate Industries and BH Spring Solutions
Certified Glock Armorer