Skyline,Originally Posted by SkyLine1
I found when I converted my P30 to V1 the trigger return felt sluggish, now I'm rocking a V4 the triggger has a very positive reset and has a more positive feel. IMHO
I measured the pull at 6lbs. 5oz
I am interested to hear other peoples opinions of the V1 trigger.
James
I've been playing with various spring combinations ... with the V1 trigger spring, the trigger doesn't feel as smooth on the uptake.
I really like the V1 (disclaimer...only version I have tried). I am also working on trigger manipulation. I find the pull to be very good and not spongy, I was able to find the break very fast and find my self able to time the trigger pull on reset. Now I'm am way below the level of quite a few on this board and you may take my opinion with a grain of salt.
If all I have to do is change out a spring to try a V4, then I just may have too just to see for myself what the hype is.
Which spring will I need to pick up to this mod?
Last edited by JM Campbell; 03-07-2011 at 01:02 PM. Reason: added question
Check out this thread on another forum
http://hkpro.com/forum/showthread.ph...-of-P30-LEM-v2
Thank you sir!
I'd also argue it makes the gun a little bit safer for carry, as well. LEM is technically DAO, but it's a bit of a wolf in sheep's clothing since the mainspring is preset meaning the trigger return spring is providing most of the resistance until you get to what's essentially a single action trigger break.
Unfortunately HKParts is out of stock on both...
Time to call HK...and of course they are out too : (
Last edited by John Ralston; 03-10-2011 at 01:14 PM.
John,
What springs are you looking for?
James
209296 & 214300 to convert my V2 to the TG V4 (Trigger and Firing pin block)
Firing Pin Block and Hammer Spring, not Trigger.
Reply With Quote