One of the French SP101s I bought a couple of years ago has a problem where the cylinder doesn’t lock up as tight as it should and can be spun without much effort when it should be locked. Reading and asking questions suggested the hand was worn. Purchased a new one from Midway and installed it which fixed the initial problem but created another where it hangs up when cocking for single action. I put it away and actually got an RMA from Ruger last October but still haven’t sent it in.
I keep looking at it and thinking fitting the hand shouldn’t be that difficult. I’m guessing it’s a little too tall but I’m not 100 percent sure.
What do I need to be looking for to see what needs to be adjusted?