G17.5 after I lightly polished the trigger bar, installed a TTI Ultimate Connector, and lubed her up. 124 gr. Lawman.
Sent from my iPhone using Tapatalk
G17.5 after I lightly polished the trigger bar, installed a TTI Ultimate Connector, and lubed her up. 124 gr. Lawman.
Sent from my iPhone using Tapatalk
The stock connector in my 17.5 appeared to be a dot connector. The TTI connector looks like a polished and worked over minus connector. The difference in feel is fairly significance. It went from a staple gun feeling to that nice and clean rolling break that I have in my G17.2 and G19.4 #1.
I originally wanted just an OEM minus connector that I would give the same light polish job that I gave the trigger bar, but everyone was out of stock. BSPS had the TTI connector in stock for roughly the same price. So I said “eh, screw it, let’s give it a shot”.
Sent from my iPhone using Tapatalk
Ben Stoeger Pro Shop
https://benstoegerproshop.com/tti-gl...l-innovations/
Sent from my iPhone using Tapatalk
G19-5. 30 rounds slow fire. 258/300. I was able to call the really bad fliers like the one in the 6 ring and the top round in the 7, but the group as a whole is low. I’m using the Ameriglo BOLD sights that came installed from the factory with a drive-the-dot sight picture. Maybe I need a shorter front?
Last edited by WobblyPossum; 08-18-2019 at 05:55 PM.
My posts only represent my personal opinion and do not necessarily reflect the opinions or official policies of any employer, past or present. Obvious spelling errors are likely the result of an iPhone keyboard.
Dan - my new Gen5 G19 MOS came with Bolds as well, and shoots pretty noticeably low. It came with a .180" front sight, I'm going to swap out with a .165" front that I've got on hand and see if that helps.
I’ve never noticed this before because I’m not a great 25y shooter and I’ve never fired a group this large before. With 10 shot groups, it’s tough for me to tell if the gun shoots low or maybe I do because I expect some spread at my skill level. I’ll give this 30 round idea a couple more attempts to see if things remain consistent.
My posts only represent my personal opinion and do not necessarily reflect the opinions or official policies of any employer, past or present. Obvious spelling errors are likely the result of an iPhone keyboard.
Today was 22 day. I've been liking my new S&W 43c revolver. I had shot it before and could mostly keep my hits in the down zero of an IDPA target at 25 yards. Today, I made several attempts at a B-8. Lots in the 80's with my best an 89. It's pretty hard to keep my elevation consistent with the big dot front sight. The surprise was my 1 attempt with my S&W M&P 22 Compact. 94, 2X. I shot a 95, 3X with my Ruger MKII with an old Tasco red dot on it. The dot kept going out. Probably needs some attention.
Last edited by BN; 08-19-2019 at 04:02 PM.