I ended up removing the plug by drilling a pilot hole, partially driving a wood screw, and pulling the plug out my the screw with pliers. It came out with little force.
Type: Posts; User: spelingmastir
I ended up removing the plug by drilling a pilot hole, partially driving a wood screw, and pulling the plug out my the screw with pliers. It came out with little force.
How’d you break them?
How have people removed these plugs? This one is in a gen 5 19 and pushing on the detent with a punch doesn’t move it. Thanks for the help.
On their pistol red dots?
I have the Holosun 509t plates. This is my preferred setup for the MOS.
I have two of the CNC plates and have a removed CHWPS plate. I found that the latter had an amount of cant that made me run out of elevation to zero at 25. The CNC plate is flat, steel, fits the form...
I started with and still have an stt. I ended up getting two spiritus lv119s because of the shoulder straps and modularity. I can shoulder a rifle better in them. Both setups use tubes for the...
147 gr ranger t shot high left at 25 for me, as compared to 115 gr ball, out of a gen 5 19. Poi was so different that I tried 115 gr barnes xpb and it hits similar to the ball. I’m happy with...
EPS is new but legit dudes have said good things. I would pick it for a 365XL because it drops right in without a plate and fits the slimmer profile.
Get the EPS! Don't need an adapter and it's enclosed.
9243392434 Pics of my setup
I think the iron sight picture would be fine. I like the irons to be as low as possible and still be usable, of course with a good zero.
I’ve since switched to a CNC Pros plate which is steel and even lower than the C&H plate. I still use the same sight combo and have a slightly better iron sight picture. I considered switching to a...
It's a personal choice and comes down to what you want to be able to do. Many people can't hit a sheet of paper from 25 yards so inches won't matter.
Update: I looked around and found that others have encountered similar problems when using the C&H plate as a result of the plate being thicker in the back(cant). I ordered a CNC Pros plate which...
Does lowering the optic help at all?
Also, I’d be happy with a good 25 yard zero and using a hold at greater distances. 2” high at 50 is awesome to me. I have held at the shoulder.
I have a 509T mounted on a gen 5 G19 MOS with C&H plate. I zero at 25 yards and elevation is maxxed out. It’s a little high with 115 grain and higher than that with heavier bullets. Would changing to...
Loctite 290 (wicking grade) into the dovetail after confirming zero. How many rounds did it take for your sight to drift?
Bob Smith's Un-Cure removes blue AND RED. Best stuff I've found. Will fully dissolve it all.
How many people have donning armor as a part of their plan? My top priority is getting to family members. Armor is put on if there is time. Also multiple belt-feds...
My carriers all use tubes and I leave one cummerbund attached and practice putting it on like that. It's pretty quick.
Can you share who taught the class? Either way, it sounds like a good one.
In. Thank you!
Ameriglo 408 rear and 285 front combination is even lower and works with the 509t/c&h mos combo. I switched from a 429 set to this.
Can you describe the mounting failure? Did the optic, plate, or both come loose?