I use M3 x 0.5 x 10mm alloy steel screws from McMaster for the 507K and EPS Carry on Sig P365X series guns. Even though the screws sit a hair deeper with the EPS they still work great.
Printable View
I use M3 x 0.5 x 10mm alloy steel screws from McMaster for the 507K and EPS Carry on Sig P365X series guns. Even though the screws sit a hair deeper with the EPS they still work great.
It’s only a sample of one. But Aaron Cowan did his usual duty test on the EPS. Doesn’t seem like there should be any concern about it holding up. Glass wasn’t fazed by his concrete drop tests and it maintained zero too.
BTW, I finally got ahold of an EPS. I dig it. Just waiting on my frame to come back from surgery.
Looks like Kenzies got a shipment.
My EPS Carry with the MRS reticle arrived today from AAAOptics. It took the post office 8 days to get my optic approximately 70 miles after it was in their possession. AAAOptics we're great and were very prompt on their end. I wouldn't hesitate to buy from them again or to say they are GTG.
Next step is to mount it up and zero it.
I got the optic installed. I pulled my 507K-X2 off of my 365XL and put it on my new 322. Then I mounted the EPS Carry on my XL. All that is left to do is to zero both guns again, which I will try to do tomorrow.
The only problem I encountered was that the screws that came with the EPS Carry would not work with the XL slide. I don't know if it was because the screws were too long, or if the threads didn't go far enough up the shank of the screws.
In either case what I did was used the screws that came with the 507K on the EPS Carry and the ones from the EPS Carry on the 507K. It worked like a charm. If I wasn't already an owner of the 507K-X2 though I would have had to procure screws that actually worked from somewhere, which kind of sucks. Not having correct screws in the box was kind of annoying.
I figure though that this discrepancy exists because Sig has changed the slide/optics cut in different versions. In the earlier versions the rear notch irons comes off with the optics plate, but the new slides for the XL leave the irons in place even if you take off the cover plate. I assume Holosun included screws that only work with the latest version of slides, but I don't know that for certain. It's just a guess.
6 moa red eps in stock at psa as of this posting
https://palmettostatearmory.com/holo...-eps-rd-6.html
I received my EPS from Brownells yesterday. Looks like my primary excuse for not carrying my dot gun (the dust bucket) has been engineered away. I bought the 6 moa model because that's what they had but think I'm going to like it a lot. Probably shouldn't like a frigging Chinese product this much but it fills the bill.
What are the best back up iron sights for the EPS carry on a Glock 43x with the MOS system? I would like the buis the lowest they can go and still be usable. I would like tritium inserts. I don’t think the Ameriglo troopers I have will work. Unfortunately I have to stay with the MOS system for work.
EuroOptic got a shipment in as well, not sure what they have but they just shipped my pre-order.